- Posts: 19
- Joined: Mon Apr 17, 2017 10:06 am
- Location: Hastings. East Sussex.
- Has thanked: 7 times
- Been thanked: 1 time
If you do or if you have but prefer 'Discrim' mode I'd be interested to hear your reasons.
I'd be grateful if the replies could come from people who have used both modes, as this will give me a better understanding of real-world experiences.
A good deep machine found a lot with mine. good on hammered , still use it on ploughed fields.
Also took the stock coil off and went for Mars tiger coil and also large cors cannon coil.
Find rate went up
C Scope 1220XD. Teknetics T2 LTD Cors Cannon Coil + Mars Tiger. Garrett Pinpointer.
Minelab Equinox 800.
- Posts: 195
- Joined: Sat Jun 11, 2016 7:54 pm
- Location: Nottinghamshire
- Has thanked: 109 times
- Been thanked: 73 times
If I find an iffy target I then switch over to A/M just to check it isn't grunting due to the target being just that bit too deep for discrimination mode to give a clear signal.
Also i use it if the signals are very few and far between.
In some case it has helped me get closer to electric fences which the T2 hates
on trashy grounds AM is too much for my ear
GP pointer (<does the job >)
Follow on instagram... dirt_scanner