CS4PI settings

All discussion specific to the Cscope CS4PI Metal Detector.
Post Reply

CS4PI settings

Post by Bully1970 » Mon Jan 02, 2017 6:27 pm

Ive had my CS4PI for about a year and usually just set ti to 3 O' clock and go.

Did some reading on here and tried some different settings to day for a while, turning up the pulse mainly but tried both settings over targets and 3 o clock seemed to work better.

Highly mineralised sand here.

Just wondered if Im best sticking to what I know or trying out something else. I go to the low tide mark in wet sand, not top of beach.

Found loads during 2016 so am pretty happy with it, just wondered if tweaking will get me deeper.

Posts: 28
Joined: Sun Mar 13, 2016 9:56 am
Location: South East England
Has thanked: 1 time
Been thanked: 2 times

Re: CS4PI settings

Post by Goldstar » Sun Jan 22, 2017 9:16 pm

I have only set up my CS4PI as directed by the manual so yet to try any other settings.
Still very new at using it and need to get a lot more hours in order to get the most out of it.
If your current settings works, then perhaps there is no need to change the settings, however its certainly worth experimenting from time to time.
Garrett ACE250 - CS4Pi

Post Reply

Return to “CScope CS4PI Forum”